• The height of a ceiling light is taken from the lowest point of the fitting to where the chain starts.
• An allowance of approximately 180mm/ 7” should be added to the height of ceiling fitting for minimal chain and ceiling rose.
• All ceiling lights are supplied with approximately 500mm of chain, if additional chain is required  please specify on order so that the fitting can be wired with equal amount of flex, additional cost may apply.
• Ceiling lights are not supplied with fixing hooks, a qualified electrician should assess the ceiling type and supply the required hooks.
• Specialist French Candle tubes can be supplied on all chandeliers and wall lights at an additional cost, sizes available are either 100mm or 170mm and take a maximum 25 Watt bulb, standard candle tubes can take max 40 Watt.
• See Bespoke Section of the Bella Figura catalogue for more information on customising certain ceiling lights in this section.

• Wall lights WL13, WL26 and WL31 are all available as opposing pairs, this means they can come as  left and right mirror images of each other, if not specified they will be supplied as pictured.
• 4” or 5” candle shades can be used on most wall lights, however we recommend half candle shades on wall lights with a projection less than 75mm/ 3”.
• Swing arm wall light heights are measured from the lowest point of the arm to the middle of the bulb holder, except on the WL90 & 91 where the arm is fully adjustable, height listed refers to the wall mounted rod.
• Shades smaller than 8” are not recommended for swing arm wall lights.
• Sample finishes can be supplied for all wall lights.
• See Bespoke Section of the Bella Figura Catalogue for more information on customising certain wall lights.

• Shades can be supplied with all global fittings, BC, ES or finial fitting, sizes smaller than 8” are supplied  with clip fittings to fix on light bulbs.
• For UK and European sizes 8” to 14” are supplied with fixed gimbal, larger sizes are with duplex fitting  supplied with suitable size shade carriers if required.
• Finial fitting shades can be supplied on all UK lamps if preferred, please specify if required as saddles  for harps and finials will need to be added.
• Pleated shades can be made in customers own fabric, an Antung or Habotai silk is recommended. Fabric must be supplied on a roll as deep creases from folding may affect the finish.
• Laminated shades can also be made in customers own fabrics, samples are required for approval  prior to order confirmation, medium weight fabrics are recommended. Fabric must be supplied on a  roll as deep creases from folding may affect the finish.

• All metal floor lamps are adjustable by approximately 300mm in height.
• Painted table floor lamps, SL02, are available with coach lines and feet that match the metal parts  chosen, we can recommend colour combinations if needed.
• Swing arm and adjustable floor lamps can rotate 360 degrees and back again.
• Swing arm and adjustable floor lamps are weighted to contract standard to avoid tipping over.
• Floor lamps are secured in their delivery boxes with a specially designed base section of packaging, to avoid damage please remove from either the side or the base of the box.
• Old English Brass and Antique Brass (black) are unique patina finishes that do not require polishing, only dry dusting.

• The height of table lamps is measured from the base to the middle of the bulb holder.
• Table lamps are supplied with 2 Metres of flex, extra flex can be supplied at an additional cost.
• A variety of Silk flex colours are available for table lamps, additional cost apply depending on length required.
• All lamps can be supplied with standard UK, European or American bulb holder.
• Standard plugs are supplied, however 5 Amp and 2 Amp plugs are available at an additional cost if required.
• Old English Brass and Antique Brass (black) are unique patina finishes that do not require polishing, only dry dusting.
• Polished brass lamps and components are not lacquered and will from time to time require polishing.